If a configured IP address can no longer be pinged, one of the device’s own digital outputs should switch and remain active until the ping has been replied to. Activating a connected actuator reports the alarm.
Once the IP-Watcher has been configured for your network and connected, the following steps are necessary:
Enter the IP address of the device in the address line of your browser.
Show the configuration menu.
Select menu point Config and log in.
Go to the page
Config >> Device >> Basic Settings >> Network
and enter any missing network parameters.
On the page
Config >> Device >> IP Watch List
add the IP address you want to monitor to the list.
Go to page
Config >> Device >> Alarm >> Alarm X
and configure the points: Alarm Enable, IP Watch List, Trigger Count, Polling Rate and Interval to specify the alarm condition.
Optionally you can assign a name to the alarm, which is displayed on the watch pages.
Activate Output Switch enable and apply the changes by clicking on Save.
On the Output Switch page specify the output you want to switch when an alarm occurs.
Exit configuration mode using Logout and save all your changes.
Connect the necessary actuators to the output terminals of the device.
