PCI Express Card 2x 20mA, 1kV isolated
Two additional 20mA ports on PC
The 13441 PCI Express card provides two independent serial 20mA interfaces with 1kV of galvanic isolation.
Properties
Interfaces:
- 2x 20mA interface
- 1x 32-bit PCIe bus
- Galvanic isolation between the ports
- Isolation voltage 1kV DC
Management and connectivity:
- UART with 128-byte FIFO and DMA capability for relieving the CPU
- Compact "x1" plug-in card for any PCI Express slots
- Compatible with PCI Express Standard 1.1 and PCI Power Management Standard 1.2
Standards & more
- Conforms to standards both in office and industrial environments:
- High noise resistance per EN 61000-6-2
- Low noise emission per EN 55032:2015 + A1 Cl. B, EN 61000-3-2 & EN 61000-3-3
- 5 year guarantee
Worth knowing
PCI Express has almost completely replaced the long-in-the-tooth PCI bus system in current PC designs. There are still PC motherboards which offer slots for both systems, but due to cost and performance considerations current boards are equipped almost exclusively with PCI Express slots.
PCI Express is not a traditional PC bus system in which all plug-in cards are in parallel with the majority of bus lines. PCI Express is rather a star type wiring technique using a point-to-point connection between the PC and plug-in card to allow significantly greater transmission speeds than a bus solution with parallel wired slots would be able to process.
Data transmission to the plug-in cards in PCI Express is serial using differential wire pairs, so-called "lanes", which run at a speed of 2.5 or 5 GB/s. For cards with high data throughput (graphics and network cards, hard drive controllers), multiple lanes are routed to a slot, whereas cards with less complexity get by easily with one lane.
The PCI Express standard enables solutions in which one (x1), four (x4), eight (x8) or 16 (x16) lanes are routed to a slot, with the connectors differing in the mechanical configuration, pin configuration and load capacity of the supply voltage.
The mechanical coding of cards and connectors ensures however that short cards can be easily used in long slots. For example, a x1 card can be used in a x4, x8 or x16 slot.
Technical data
Connections and displays:
- PCIe port:
- PCIe 1.1 / "x1" connector
- Serial port:
- 2x 20mA interface
- 9-pin SUB-D adapter
- Operating modes:
- suitable for active or passive mode
- Maximum baud rate:
- 57600 baud
- Data format:
- any format
- Signals:
- RxD, TxD
- UART:
- PI7C9X7952BFDE with 128 bytes FIFO
- Galvanic isolation:
- Isolation voltage min. 1kV DC
- between PC and serial ports
- Supply voltage:
- 3.3V DC, 12V DC
- Current consumption:
- typ. 200mA @ 3.3V
- typ. 200mA @ 12V
Housing and other data:
- Dimensions:
- 95 x 120mm (W x H)
- Enclosure rating:
- IP00
- Weight:
- approx. 100g
- Ambient temperature:
- Storage: -40..+70°C
- Operating: 0..+70°C
- Permissible relative humidity:
- 5..95% RH, non-condensing
- Scope of delivery:
- PCIe card 2x 20mA
- Quick start manual
* Our offering is intended only for commercial users. We will be happy to refer private end customers to trading partners through whom our products can be purchased.