Web-IO 4.0 Analog-In/Out
The combined solution for analog in- or output signals brings your measurement values into the network and back to the terminal.
Use the Web-IO Analog-In/Out to measure analog signals, tunnel them through the network and output them again as analog signals at a remote location. For example you can control an analog meter which displays the level of a distant tank.
Technical data
| Current input passive: | 0-20mA, 100Ohm |
| Current input active: | 0-20mA, burden max. 500Ohm, active voltage Umax 14V / 40mA |
| Current output: | 0 - 20mA, burden max. 500 Ohms, supply 10V guaranteed |
| Current loop monitoring: | Short circuit protected and open-loop detection |
| Measuring unit | |
| Resolution: | Current input: 2.5µA |
| Measuring error: | max. 0.5% FSR (Full Scale Range 0-20mA) TA = 0-60°C |
| Storage frequency: | 15, 30 sec., 1, 5, 15, 60 min |
| Memory depth: | min. 150 days, max. 99 years |
| Measurement value acquisition: (can be polled over the network and trigger an alarm) |
2/second |
| Voltage input: | 0-10V, 1MOhm |
| Voltage output: | 0-10V, Imax 20mA Sense line can be activated |
| Measuring unit | |
| Resolution: | Voltage input: 1.25mV |
| Measuring error: | max. 0.5% FSR (Full Scale Range 0 - 10V) TA = 0-60°C |
| Storage frequency: | 15, 30 sec., 1, 5, 15, 60 min |
| Memory depth: | min. 150 days, max. 99 years |
| Measurement value acquisition: (can be polled over the network and trigger an alarm) |
2/second |
The Web-IO 4.0 Analog-In/Out brings your analog measurements into the network and allows you to connect analog meters, as well as a variety of other application possibilities.
Now test for 30 days with no obligation:
More information about the Web-IO Analog-In/Out can be found at: www.wut.de/57761 or www.wut.de/57762