Wiesemann & Theis GmbH

Networking, sensors and interface technology for industry, office and IT

House
Firmware:

Com-Server OEM Mini, 10BT

#58411

Current firmware
Date Changes and comments Revision
August 4, 2006
  • Device-internal self-test adjusted
 1.33
UHD download
 Show older firmware...Hide older firmware...
Older firmware
Date Changes and comments Revision
May 30, 2006
  • Optimized configuration uploading
  • Cosmetic corrections in Telnet menu
 1.32
UHD download
March 10, 2006
  • TCP checksum calculation expanded
  • Optimized generation of GARPs after reset and link loss
 1.31
UHD download
April 19, 2005
  • Assigning the subnet mask and gateway address through the serial port
  • Support for Easy start! used with WuTility 3.03
 1.30
UHD download
January 5, 2005
  • Interoperability problems with some DHCP servers remedied
  • Assigning/changing the IP address with WuTility is
    also possible for IP address > 0.0.0.0 (only in conjunction
    with WuTility Version 2.61 and higher)
 1.29
UHD download
November 16, 2004
  • Modified behavior in FTP client mode with
    serial login string
  • Revision of IP bus mode
 1.28
BIN download
February 9, 2004
  • Introduction of an active keep-alive check.
    At adjustable intervals, the Com-Server verifies in a
    stand-alone fashion whether a TCP connection is still valid
  • Deactivation of the BOOTP client simultaneously
    switches off the RARP protocol too.
 1.27
BIN download
March 13, 2003
  • Optimizing the control port 9094
  • Adapting the "UDP-Client with serial addressing" mode
 1.26
BIN download
October 1, 2002
  • TELNET: Option with binary support
  • TELNET: Xon/Xoff handling optimized
  • TCP Server: Alternating access from Com-Port Redirector and normal socket connection possible
  • SNMP: Optimized walk over entire MIB
 1.25
BIN download
March 21, 2002
  • BOOTP: Vendor-specific area with fixed length
  • FTP Client: Problems opening a connection and simultaneous
    long response times in the network eliminated
  • Control port 9094: Error with Clear_Break eliminated
  • Baud rate divisor is freely definable
    via Telnet configuration
 1.24
BIN download
January 25, 2002
  • Sending of "Gratuitous ARP" at bootup
    (required for address management of some switches)
  • UDP Mode: Sending of broadcasts now possible
  • Optimized ARP handling
  • SLIP Mode: Problem when running without handshake eliminated
  • FTP Client: Problem when destination IP contains 0 bytes eliminated
    (applies only to some FTP servers)
 1.23
BIN download
July 26, 2001
  • Visual corrections in Telnet configuration menu
  • FTP Client mode with serial protocol:
    To enable binary transmissions, the Protocol Char is no longer evaluated when using TYPE I. Connection is ended by means of Inactivity Timeout
 1.22
BIN download
June 6, 2001
  • Com-Server standard Industry Version, 10BT
 1.21
BIN download
Hide older firmware...



^