Wiesemann & Theis GmbH

Networking, sensors and interface technology for industry, office and IT

  Due to maintenance work, there may be some problems on our website from 24.03. to 26.03.2025.
  For urgent inquiries you can reach us at: +49202/2680-0

Firmware:

Com-Server Standard Industry, 10BT, 24V

Model 58611

Current firmware
Date Changes and comments Revision
August 4, 2006
  • Device-internal self-test adjusted
 1.33
UHD download
 Show older firmware...Hide older firmware...
Older firmware
Date Changes and comments Revision
May 30, 2006
  • Optimized configuration uploading
  • Cosmetic corrections in Telnet menu
 1.32
UHD download
March 10, 2006
  • TCP checksum calculation expanded
  • Optimized generation of GARPs after reset and link loss
 1.31
UHD download
April 19, 2005
  • Assigning the subnet mask and gateway address through the serial port
  • Support for Easy start! used with WuTility 3.03
 1.30
UHD download
January 5, 2005
  • Interoperability problems with some DHCP servers remedied
  • Assigning/changing the IP address with WuTility is
    also possible for IP address > 0.0.0.0 (only in conjunction
    with WuTility Version 2.61 and higher)
 1.29
UHD download
November 16, 2004
  • Modified behavior in FTP client mode with
    serial login string
  • Revision of IP bus mode
 1.28
BIN download
February 9, 2004
  • Introduction of an active keep-alive check.
    At adjustable intervals, the Com-Server verifies in a
    stand-alone fashion whether a TCP connection is still valid
  • Deactivation of the BOOTP client simultaneously
    switches off the RARP protocol too.
 1.27
BIN download
March 13, 2003
  • Optimizing the control port 9094
  • Adapting the "UDP-Client with serial addressing" mode
 1.26
BIN download
October 1, 2002
  • TELNET: Option with binary support
  • TELNET: Xon/Xoff handling optimized
  • TCP Server: Alternating access from Com-Port Redirector and normal socket connection possible
  • SNMP: Optimized walk over entire MIB
 1.25
BIN download
March 21, 2002
  • BOOTP: Vendor-specific area with fixed length
  • FTP Client: Problems opening a connection and simultaneous
    long response times in the network eliminated
  • Control port 9094: Error with Clear_Break eliminated
  • Baud rate divisor is freely definable
    via Telnet configuration
 1.24
BIN download
January 25, 2002
  • Sending of "Gratuitous ARP" at bootup
    (required for address management of some switches)
  • UDP Mode: Sending of broadcasts now possible
  • Optimized ARP handling
  • SLIP Mode: Problem when running without handshake eliminated
  • FTP Client: Problem when destination IP contains 0 bytes eliminated
    (applies only to some FTP servers)
 1.23
BIN download
July 26, 2001
  • Visual corrections in Telnet configuration menu
  • FTP Client mode with serial protocol:
    To enable binary transmissions, the Protocol Char is no longer evaluated when using TYPE I. Connection is ended by means of Inactivity Timeout
 1.22
BIN download
June 6, 2001
  • Com-Server standard Industry Version, 10BT
 1.21
BIN download
Hide older firmware...

^