LAN modem, 10/100BT, 24V
Replacement of a dial-up modem route through LAN modems
- Network adapters:
- 10/100BT autosensing
- Power supply:
- 12-24 volts AC/DC
- Shipped optionally with or without power supply:
Please order power supplies as separate accessories.
Conforms to standards both in office and industrial environments:
- High noise resistance for industrial environments
- Low noise emission for residential and business areas
- 5 year guarantee
Alarm systems, test equipment, air conditioning monitoring systems and their associated control programs often require that a dial-up modem be connected to the RS232 port in order to exchange alarms or configuration data.
For in-house applications this means reserving at least two of the few available direct dial numbers in a telephone system. If the communication partner is located at a remote site, you must add to this long-distance or dedicated line lease charges. The W&T LAN modem makes it possible to route such connections over the already existing LAN. Use of TCP/IP protocol permits both intranet and Internet accesses to be utilized as the communications path.
The RS232 port on the LAN modems, which operates at a data rate of 57,600 baud, emulates the Modem-AT command set and converts it into TCP/IP and Ethernet at 10 as well as with 100MBit/s.
To use the LAN modem, all you need to do is replace the previous telephone number with the IP address of the destination modem. No other changes are necessary!
The W&T LAN modem allows you to integrate modem-based systems into the network without any modification to the software or firmware.
Virtual modem ports under Windows:
The COM Port Redirector for Windows NT/2000/XP/2003 allows you to set up virtual COM ports that emulate a LAN modem. Both incoming and outgoing calls are supported, so that no external hardware is required on the side of the central application. Interested?
- 10/100BaseT autosensing
- (IPv6 on request)
- Serial port:
- 1 x RS232 interface
- DB9 socket, DCE assignment
- Baud rate:
- 1200 to 57,600 baud
- Data format:
- 8 data bits, 1 stop bit, no parity
- Flow control:
- Hardware handshake and/or
- XON/XOFF protocol
- Galvanic isolation:
- min. 500 volts
- Supply voltage:
- DC 12V .. 48V (+/-10%)
- AC: 9Veff .. 30Veff (+/-10%)
- Current consumption:
- Typ. 100 mA @24 V DC
- Ambient storage temperature:
- Ambient operating temperature:
- non-cascaded: 0..+60°C
- cascaded: 0..+50°C
- Plastic compact enclosure, 105x75x22mm
- approx. 200 g
- Scope of delivery:
- 1x LAN modem 58620
Please order power supplies separately as accessories