| March 10, 2006 |
- TCP checksum calculation expanded
- Optimized generation of GARPs after reset and link loss
|
1.31
on request |
| April 19, 2005 |
- Assigning the subnet mask and gateway address through the serial port
|
1.30
on request |
| January 5, 2005 |
- Interoperability problems with some DHCP servers
rectified
- Assigning/changing the IP address with WuTility is
also possible for IP address > 0.0.0.0 (only in conjunction
with WuTility Version 2.61 and higher)
|
1.29
on request |
| November 16, 2004 |
- Modified behavior in FTP client mode with
serial login string
- Optimizing in IP bus mode
|
1.28
on request |
| February 9, 2004 |
- Introduction of an active keep-alive check.
At adjustable intervals, the Com-Server verifies in a
stand-alone fashion whether a TCP connection is still valid
- Deactivation of the BOOTP client simultaneously
switches off the RARP protocol too.
|
1.27
on request |
| March 13, 2003 |
- Optimizing the control port 9094
- Adapting the "UDP-Client with serial addressing" mode
|
1.26
on request |
| October 1, 2002 |
- TELNET: Option with binary support
- TELNET: Xon/Xoff handling optimized
- TCP Server: Alternating access from Com-Port Redirector and normal socket connection possible
- SNMP: Optimized walk over entire MIB
|
1.25
on request |
| March 21, 2002 |
- BOOTP: Vendor-specific area with fixed length
- FTP Client: Problems opening a connection and simultaneous
long response times in the network eliminated
- Control port 9094: Error with Clear_Break eliminated
- Baud rate divisor is freely definable
via Telnet configuration
|
1.24
on request |
| January 25, 2002 |
- Sending of "Gratuitous ARP" at bootup
(required for address management of some switches)
- UDP Mode: Sending of broadcasts now possible
- Optimized ARP handling
- SLIP Mode: Problem when running without handshake eliminated
- FTP Client: Problem when destination IP contains 0 bytes eliminated
(applies only to some FTP servers)
|
1.23
on request |
| July 26, 2001 |
- Visual corrections in Telnet configuration menu
- FTP Client mode with serial protocol:
To enable binary transmissions, the Protocol Char is no longer evaluated when using TYPE I. Connection is ended by means of Inactivity Timeout
|
1.22
on request |
| June 6, 2001 |
- Com-Server standard Industry Version, 10/100 BT
|
1.21
on request |
